Summary:
Precautions when assembling 608 bearings
Following the previous article on how to choose 608 bearings, the editor of Ji...
Precautions when assembling 608 bearings
Following the previous article on how to choose 608 bearings, the editor of Jiashi Bearings brings you what are the precautions when assembling 608 bearings.
1.608 bearing applications must be kept clean. Any impurities will adversely affect the use and life of the bearing. For open bearings, you can use a suitable cleaning agent (cleaning kerosene) to clean, and then fill in the lubricant.
2. When installing 608 bearings, do not allow the inner and outer rings of the bearing to be relatively stressed, otherwise it will easily cause internal damage to the bearing (cloth indentation). In order to facilitate installation, the bearing can be heated, but the heating temperature cannot exceed 120°C.
3. After the bearing is installed, you should try to rotate it to check whether it is installed correctly. If the bearing does not rotate normally, the cause of the failure needs to be detected.
4. It is not recommended to use lubricating oil and grease for lubrication at the same time.
5. The bearing should be kept in a clean and constant temperature place. Be careful when taking it to prevent damage and corrosion.
6. Before the bearing is used, wipe the shaft and bearing seat with a lint-free cloth to prevent impurities from entering the bearing.
China Ring Bearings Suppliers
