News

  • Main reasons affecting the performance of self-lubricating bearings

    Main reasons affecting the performance of self-lubricating bearings

    What are the main reasons that affect the performance of self-lubricating bearings? The performance of self-lubricating bearings is largely affected by the surface roughness and hardness of matching bearing materials. High-quality shaft surfaces can extend bearing life. On the contrary, rough, low-h... read more

    21-10-2020 News
  • The relationship between bearing materials and performance

    The relationship between bearing materials and performance

    The ferrule and rolling body of the rolling bearing are subjected to high touch pressure while being repetitively touched while sliding. The retainer slides and touches the ferrule and the rolling body on either side or one of its sides, and the pulling force and shortening force are applied on the ... read more

    21-10-2020 News
  • The relationship between bearing materials and performance

    The relationship between bearing materials and performance

    The ferrule and rolling body of the rolling bearing are subjected to high touch pressure while being repetitively touched while sliding. The retainer, on one side, slides and touches the sides of the ferrule and the tumbling body, or one of its sides, and is subject to tensile and contractive forces... read more

    21-10-2020 News
  • The bearing should be replaced in the following situations

    The bearing should be replaced in the following situations

    Introduce the bearing to any of the following conditions, please do not continue to use, you should immediately replace the new bearing to prevent unnecessary incidents. 1. There is a break in any one of the bearing ring and rolling body; 2. The inner diameter surface of the inner ring of the bearin... read more

    21-10-2020 News
  • The most prone faults of sliding bearings

    The most prone faults of sliding bearings

    When sliding bearings work, the contact between the journal and the bearing bush will conflict, resulting in heat, wear and even "bite". Therefore, when planning the bearing, the sliding bearing materials with good friction reduction should be used to make the bearing bush and select the appropriate... read more

    21-10-2020 News